

Nothing has changed yet up pops an alarm. Lasts for about 3 - 5 seconds, no change in the SM display. If you have SM connected to MK IIOr MK III, you should also set MK II/MK III to display "iLINKThere is no way to know what is causing the alarm without theMy configuration is an IC-7800 driving an IC-PW1.How are SM/7800/PW-1 connected? Is an MK II/MK III also in use?I'm in the middle of a contact and all of sudden during a transmission the SM emits an audible alarm along with a blinking red alarm light. 2 OSC UNIT ADJUSTMENTS REFERENCE OUTPUT REF IN OUTPUT REF OUT OUTPUT ADJUSTMENT ADJUSTMENT ADJUSTMENT CONDITION MEASUREMENT VALUE POINT UNIT LOCATION UNIT ADJUST 1 2 3The best chance to catch it. 10 This output level of a standard signal generator (SSG) is indicated as SSG’s open circuit.
My configuration is an IC-7800 driving an IC-PW1. I am only using the SM to switch/manage antennas and I remain connected to the correct antenna at all times. It doesn't happen with any repeatability and I would say it is a low probability event.
Ic-7800 Setup With Microham Mkii How To Resolve The
Last night I finally caught it in the act. The SM is not connected to the computer which is only done when necessary to manage the Router which hasn’t been changed since I set it up a year ago. A CI-V polling impact? Any idea or suggestion how to resolve the alarm condition? It has been happening for many months but since I wear headphones by the time, I hear the beeping, it has gone away.
